- FREQ RESP: 20 HZ 50 KHZ 3 DB; OUTPUT POWER @ 14.4V DC, 50 HZ; 2 OHM STABLE; MOSFET POWER SUPPLY; PWM SYSTEM; GLASS EPOXY PCB; SILVER RCA INPUTS; CUSTOM TERMINAL BLOCK FOR SPEAKER CONNECTION; THERMAL/OVERLOAD/SHORT CIRCUIT PROTECTION; INPUT IMP: 47K OHM; SOFT TURN ON/OFF; ADVANCED PROTECTION CIRCUITRY; SIGNAL-TO-NOISE RATIO: >90 DB; DIM:10.24″W X 2.21″H; 2-CHANNEL; 4000W MAX POWER; 1 X 4000W @ 4 OH
Product Description
Maximum Power Output 2 x 2000W bridgeable RMS Power @ 4 Ohms: 1×4000W 2 Channel idgeable MOSFET Amplifier Frequency Response 20 Hz-50kHz (±3dB) Output Power @ 14.4v DC, 50Hz 2 Ohm Stable MOSFET Power Supply PWM ( Pulse-Width-Modulation ) System Glass Epoxy PCB Silver RCA Inputs Custom Terminal Block for Speaker Connection Thermal / Overload / Short Circuit Protection Input Impedance: 47K Ohms Soft Turn On/ Off Advanced Protection Circuitry S/N Ratio: … More >>
PYLE PLA2678 2 Channel 4000 Watts Bridgeable Mosfet Amplifier
Tags: 4 ohms, amplifier frequency response, input impedance, mosfet power supply, protection circuitry, pulse width modulation, rca inputs, rms power, signal to noise ratio, speaker connection
#1 by Joseph C. Wieczezak on June 23, 2010 - 1:05 pm
just purchased the pyle pl2678 2 channel amp for a replacement for my old sony xplode and it certainly was worth the money it is a lot louder and packs a good punch for my 2 1000 watt subs! I am afraid to turn the volume up for fear of blowing the subs or breaking my rear window it certainly is much more powerfull than my old sony amp and runs alot cooler than the sony wich kept overheating and turned off very often haven’t had that problem yet with the pyle amp, so pick one up you can’t go wrong for the money!
Rating: 4 / 5